part_knocks_shifts
This is an old revision of the document!
Table of Contents
What causes parts to be knocked off or shit on the plate?
Normally this is caused by a combination of the following issues:
Poor Choice of Infill Pattern
Infill patterns that cross already drawn infill lines (e.g. grid) are inconsistent with high print velocities. Use patterns like Cross Hatch, Gyroid or Honeycomb instead. Patterns like Cross Hatch offer a good balance of strength and speed along with requiring less infill density (%) than other patterns to achieve the same coverage.
Misaligned Gantry
Flow Ratio Too High
- Tune Extruder Rotational Distance
- Tune flow ratio
- Tune Pressure Advance
Bad gcode Z Offset
Properly set z-offset
Other Tips
- Retract between layers and enable z hop on retraction
- Avoid crossing perimeters
/app/data/attic/part_knocks_shifts.1758323284.txt.gz · Last modified: by dshoop