skip to content
Neptune4.help
FAQs and Facts for the Elegoo Neptune 4 Series 3D Printer
User Tools
Log In
Site Tools
Search
Tools
Show pagesource
Old revisions
Backlinks
Recent Changes
Media Manager
Sitemap
Log In
>
Recent Changes
Media Manager
Sitemap
You are here:
Welcome
»
nozzle_types
Trace:
•
nozzle_types
Sidebar
Index
Welcome
See a list of
Resources
First Time Printer Setup
Frequently Asked Questions
Setup Articles
Show Support
Buy me a coffee
Donate
Articles
Bed Leveling vs the Bed Mesh
Cleaning the Bed Plate
Good and Bad Z Offset In The Wild
How to run a Bed Mesh
Layer Height Composition
Print Start Workflows
Setting Up Your Neptune 4 Printer For The First Time
Tips for better first layers
Tuning the Z Probe configuration
Understanding the gcode Z offset
What are Klipper Macros?
What causes parts to be knocked off or shift on the bed plate?
About...
A Purge Filament Macro
Adpative Bed Mesh
Bed Mesh
Cleaning the Bed Plate
Console
Fluidd
Gantry Alignment
gcode
Glue
Klipper
Layer Height Composition
Nozzle Replacement
Nozzle Types
OpenNeptune
Orca Calibration
Orca Dimensional Accuracy Compensation
Orca Slicer
PID Tuning
Pressure Advance
Print Start Workflows
PRINT_START Macro
printer.cfg File
SCREWS_TILT_CALCULATE
Silicone Spacers
The Screen controller
What are Klipper Macros?
Z Offset
z probe
FAQ
Food Safe Prints?
How can you revert the printer firmware back to the original state?
How should I clean the bed?
How should I set the Z Offset to adjust nozzle height?
How to run a Bed Mesh
Important Changes
Nozzle Replacement
Nozzle Types
Should you update the firmware?
Tips for better first layers
What are good retraction settings?
What are Klipper Macros?
What causes parts to be knocked off or shift on the bed plate?
What do I need to do after swapping my nozzle, hot end or toolhead?
What do the numbers on the Level screen tell me?
What is a Slicer?
Where can I find further resources?
Why are feeler gauges a bad idea and in general just wooly thinking?
Why can't I get a good first layer?
Why can't I move the print head or build plate?
Why does the Z Offset Drift, Vary or is Lost?
Why is Orca slower than Cura?
Why should I set the Z Offset to adjust nozzle height?
Why shouldn't the z offset be saved?
nozzle_types
This is an old revision of the document!
/app/data/attic/nozzle_types.1763627571.txt.gz
· Last modified:
2025/12/01 17:47
(external edit)
Page Tools
Show pagesource
Old revisions
Backlinks
Back to top
