1. Unbox and assemble your printer
2. Connect your printer to your local network
   
3. A word about printer.cfg
4. Tune Z Probe configuration to improve accuracy and speed
5. Tune stepper motor configurations for accuracy & noise
6. Tune the extruder rotational distance
7. Level the gantry
8. A word about bed_leveling
9. Level the bed by running SCREWS_TILT_CALCULATE
10. A word about the bed_mesh
11. Run a full bed mesh
12. Inspect the bed mesh for gross warpage
13. Adjust Nozzle Height - Z Offset
    1. paper method
    2. baby step calibrated

• A word about PRINT_START macro
• A word about silicon spacers

Printing the presliced Buddha that Elegoo distributes is a good test as its known good gcode for the Neptune 4 that's been calibrated for Elegoo's PLA Filament.

If you're not using a filament with and already defined filament profile it's recommended you calibrate a profile for it as it will result in improvements over using any default profiles (which are more of a suggested basis to start from.)

Orca slicer offers excellent calibration tools for determining common filament parameters. These can and will vary between the filament you're using, even with respect sometimes to filament color.

For calibrating flow rate, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker: https://www.printables.com/model/1113488-flexi-flow-calibration-tool-v4-by-ck3d

Use your slicer to create a primitive object, a cube, and slice it with your test slicer settings and try to print it.

No. < discuss >