faq
This is an old revision of the document!
Neptune 4 Frequently Asked Questions
- How can you revert the printer firmware back to the original state?
- How should I clean the bed?
- How should I set the Z Offset to adjust nozzle height?
- How to run a Bed Mesh
- Nozzle Replacement
- Should you update the firmware?
- What are good retraction settings?
- What are Klipper Macros?
- What causes parts to be knocked off or shift on the bed plate?
- What is a Slicer?
- Where can I find further resources?
- Why are feeler gauges a bad idea and in general just wooly thinking?
- Why can't I get a good first layer?
- Why can't I move the print head or build plate?
- Why does the Z Offset Drift, Vary or is Lost?
- Why should I set the Z Offset to adjust nozzle height?
- Why shouldn't the z offset be saved?
<blog pagination> blog faq cache 0 limit 6 </blog>
/app/data/attic/faq.1757300406.txt.gz · Last modified: (external edit)