Index
Welcome
See a list of
Resources
First Time Printer Setup
Frequently Asked Questions
Setup Articles
Show Support
Buy me a coffee
Donate
Articles
Bed Leveling vs the Bed Mesh
Cleaning the Bed Plate
Setting Up Your Neptune 4 Printer For The First Time
Understanding the gcode Z offset
What are Klipper Macros?
What causes parts to be knocked off or shift on the bed plate?
About...
Adpative Bed Mesh
Bed Mesh
Cleaning the Bed Plate
Console
Fluidd
Gantry Alignment
gcode
Glue
Klipper
Nozzle Replacement
OpenNeptune
Orca Calibration
Orca Dimensional Accuracy Compensation
Orca Slicer
PID Tuning
PRINT_START Macro
printer.cfg File
SCREWS_TILT_CALCULATE
Silicone Spacers
The Screen controller
What are Klipper Macros?
Z Offset
FAQ
How can you revert the printer firmware back to the original state?
How should I clean the bed?
How should I set the Z Offset to adjust nozzle height?
How to run a Bed Mesh
Nozzle Replacement
Should you update the firmware?
What are good retraction settings?
What are Klipper Macros?
What causes parts to be knocked off or shift on the bed plate?
What is a Slicer?
Where can I find further resources?
Why are feeler gauges a bad idea and in general just wooly thinking?
Why can't I get a good first layer?
Why can't I move the print head or build plate?
Why does the Z Offset Drift, Vary or is Lost?
Why should I set the Z Offset to adjust nozzle height?
Why shouldn't the z offset be saved?