Neptune 4 Frequently Asked Questions
Food Safe Prints?
How can you revert the printer firmware back to the original state?
How should I clean the bed?
How should I set the Z Offset to adjust nozzle height?
How to run a Bed Mesh
Important Changes
Nozzle Replacement
Nozzle Types
Should you update the firmware?
Tips for better first layers
What are good retraction settings?
What are Klipper Macros?
What causes parts to be knocked off or shift on the bed plate?
What do I need to do after swapping my nozzle, hot end or toolhead?
What do the numbers on the Level screen tell me?
What is a Slicer?
Where can I find further resources?
Why are feeler gauges a bad idea and in general just wooly thinking?
Why can't I get a good first layer?
Why can't I move the print head or build plate?
Why does the Z Offset Drift, Vary or is Lost?
Why is Orca slower than Cura?
Why should I set the Z Offset to adjust nozzle height?
Why shouldn't the z offset be saved?