====== Why is Orca slower than Cura? ======
{{tag>> faq}}

===== Issue: ======
Users report that when they switch from slicing with Cura to slicing with Orca their prints take longer to print.. 

===== Answer: =====

It's not. This is a user configuration issue. 

The filament profile Max Volumetric Flow Rate limits overall print speed, as calibration not present in Cura. The default filament profiles for default PLAs and other materials are set to the lowest common denominator to better assure reliable prints yet are normally set significantly lower than necessary for printing. 

The correct fix is to run Orca's Max Volumetric Flow Rate Calibration test to determine the correct value for the specific filament. 

The cheap and dirty fix is to raise it to 12, 16, 18, 24, or 28 mm^3/s (for PLA) until you see poor results. 

Increasing the max volumetric flow rate will allow the print velocities to approach the process speed settings.