Neptune4.help

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Z Offset ======
{{tag>z_offset about}}

To be clear, this is a discussion about the gcode z offset, an adjustment to nozzle height from the plate. 

The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset . All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''

{{ :9tbrmczrjfdqftu3tcgbnc-1200-80.png?600 |}}

==== Z Offset Articles ====

[[https://www.wevolver.com/article/z-offset| Revolver: Calibrating Your 3D Printer's Z Offset Setting]]

=== Tom's Hardware ===

==How to Correctly Set a 3D Printer's Z-Offset==
https://www.tomshardware.com/how-to/correctly-set-3d-printer-z-offset\\
A fair article that includes more than the paper method and viable for most any printer.\\