Neptune4.help

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== Setting Up Your Neptune 4 Printer For The First Time ======
{{tag>articles}}


  - [[unbox_and_assemble_your_printer|Unbox and assemble your printer]]
  - [[connect_the_printer_to_your_network|Connect your printer to your local network]]\\
  - A word about [[printer.cfg]]
  - [[tune_probe_configurations|Tune Z Probe configuration to improve accuracy and speed]]
  - [[tune_stepper_configurations|Tune stepper motor configurations for accuracy & noise]]
  - [[tune_extruder_rotational_distance| Tune the extruder rotational distance]]
  - [[aligning_the_gantry|Level the gantry]]
  - A word about [[bed_leveling]]
  - [[running SCREWS_TILT_CALCULATE|Level the bed by running SCREWS_TILT_CALCULATE]]
  - A word about the [[bed_mesh]]
  - [[run_a_full_bed_mesh|Run a full bed mesh]]
  - [[inspect_bed_mesh|Inspect the bed mesh for gross warpage]]
  - [[how_should_i_set_the_z_offset_to_adjust_nozzle_height|Adjust Nozzle Height - Z Offset]]
    - paper method
    - baby step calibrated

  * A word about [[PRINT_START macro]]
  * A word about [[silicone_spacers|silicon spacers]]


=== Running a test print -- The Buddha ===

Printing the presliced Buddha that Elegoo distributes is a good test as its known good gcode for the Neptune 4 that's been calibrated for Elegoo's PLA Filament. 

=== Calibrate a profile for your filament ===

If you're not using a filament with and already defined filament profile it's recommended you calibrate a profile for it as it will result in improvements over using any default profiles (which are more of a suggested basis to start from.) 

Orca slicer offers excellent calibration tools for determining common filament parameters. These can and will vary between the filament you're using, even with respect sometimes to filament color. 

For calibrating flow rate, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker:
https://www.printables.com/model/1113488-flexi-flow-calibration-tool-v4-by-ck3d

=== Running a test print -- Slice a cube ===

Use your slicer to create a primitive object, a cube, and slice it with your test slicer settings and try to print it.  

=== Next Steps ===

Learn to use [[Orca Slicer]]


Perform [[Orca Calibrations]] to build a [[filament profile]] for the specific filament you will be using. These filament profiles will vary between material (PLA, PETG, TPU, ASA, ABS, ...), type (standard, high speed, high temp, plus, "silk", matte, ...), brand and even color. 

==== Notes ====

Do not tighten or adjust the lock nuts for the lead screw couplers to the gantry. They are set at the factory (lock nuts) and need to be loose. Adjusting lock nuts damages them. 

=== Should you update the "firmware" ===

No. < [[should_update_firmware|Discussion]] >