z_probe_configuration_tuning
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| z_probe_configuration_tuning [2025/08/30 01:31] – ↷ Page moved from printer_set_up:z_probe_configuration_tuning to z_probe_configuration_tuning dshoop | z_probe_configuration_tuning [2025/09/14 01:52] (current) – dshoop | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| The probe is capable of measuring sub-micron distances and is also used to map the bed to map a | The probe is capable of measuring sub-micron distances and is also used to map the bed to map a | ||
| - | [[..bed mesh]], and can be used to measure the distance the nozzle is from the plate, so it can also tell | + | [[bed mesh]], and can be used to measure the distance the nozzle is from the plate, so it can also tell |
| us if the bed is level, and more. | us if the bed is level, and more. | ||
| Line 17: | Line 17: | ||
| the actual distance through interpolation. However each addition probe reading takes time. | the actual distance through interpolation. However each addition probe reading takes time. | ||
| - | Both the [[about:klipper]] and Elegoo defaults allow for far more error tolerance than is respectable and it's | + | Both the [[klipper]] and Elegoo defaults allow for far more error tolerance than is respectable and it's |
| configuration can be configured to produce better results, faster and with more accuracy using fewer probe | configuration can be configured to produce better results, faster and with more accuracy using fewer probe | ||
| readings. | readings. | ||
/app/data/attic/z_probe_configuration_tuning.1756531904.txt.gz · Last modified: (external edit)