Differences

This shows you the differences between two versions of the page.

--- z_offset [2025/10/08 14:22] – ↷ Page name changed from z-offset to z_offset dshoop
+++ z_offset [2025/11/25 00:51] (current) – dshoop
@@ Line 2: / Line 2: @@
 {{tag>z_offset about}}
-To be clear, this is a discussion about the gcode z offset, an adjustment to nozzle height from the plate.
+To be clear, this is a discussion about the gcode z offset, an adjustment to nozzle height from the plate. (It should not be conflated with the probe z offset.)
 The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset . All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''
@@ Line 16: / Line 16: @@
-==== Z Offset Articles ====
+==== Neptune 4 Help Z Offset Topics===
+{{topic>z_offset&simplelist}}
+==== Other Z Offset Articles ====
 [[https://www.wevolver.com/article/z-offset| Revolver: Calibrating Your 3D Printer's Z Offset Setting]]