Differences

This shows you the differences between two versions of the page.

--- z-offset [2025/09/13 23:31] – external edit 127.0.0.1
+++ z-offset [2025/09/19 19:06] (current) – dshoop
@@ Line 1: / Line 1: @@
-====== Z-Offset ======
+====== Z Offset ======
-{{tag>z-offset about setup}}
+{{tag>z_offset about}}
 To be clear, this is a discussion about the gcode z offset, an adjustment to nozzle height from the plate.
-The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset
+The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset . All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''
-All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''
 {{ :9tbrmczrjfdqftu3tcgbnc-1200-80.png?600 |}}