Differences

This shows you the differences between two versions of the page.

--- z-offset [2025/08/30 03:40] – [Z Offset Articles] dshoop
+++ z-offset [2025/09/19 19:06] (current) – dshoop
@@ Line 1: / Line 1: @@
-====== Z-Offset ======
+====== Z Offset ======
-{{tag>z-offset about setup}}
+{{tag>z_offset about}}
 To be clear, this is a discussion about the gcode z offset, an adjustment to nozzle height from the plate.
-The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset
+The gcode z offset is set with the ''SET_GCODE_OFFSET'' klipper command and you should read its documentation, at https://www.klipper3d.org/G-Codes.html#set_gcode_offset . All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''
-All other methods of changing the value just equate to this command. You can set it to a absolute value like ''SET_GCODE_OFFSET Z=0.075'' or adjust it relative to its current value like ''SET_GCODE_OFFSET Z_ADJUST=0.030''
 {{ :9tbrmczrjfdqftu3tcgbnc-1200-80.png?600 |}}
@@ Line 15: / Line 14: @@
 === Tom's Hardware ===
-[[https://www.tomshardware.com/how-to/correctly-set-3d-printer-z-offset|How to Correctly Set a 3D Printer's Z-Offset]]
+==How to Correctly Set a 3D Printer's Z-Offset==
+https://www.tomshardware.com/how-to/correctly-set-3d-printer-z-offset\\
 A fair article that includes more than the paper method and viable for most any printer.\\