Differences

This shows you the differences between two versions of the page.

--- why_shouldn_t_the_z_offset_be_saved [2025/09/14 02:33] – [Answer:] dshoop
+++ why_shouldn_t_the_z_offset_be_saved [2025/09/14 02:34] (current) – [Answer:] dshoop
@@ Line 8: / Line 8: @@
 For various different reasons the value isn't a consistent single value worth saving:
- * varies by filament
+  * varies by filament
- * varies by initial layer height
+  * varies by initial layer height
- * if using with an uncalibrated probe and so including an error adjustment value this won't be a consistent value with saving
+  * if using with an uncalibrated probe and so including an error adjustment value this won't be a consistent value with saving because of the changing error adjustment.