why_not_feeler_gauges
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| why_not_feeler_gauges [2025/09/20 16:19] – created dshoop | why_not_feeler_gauges [2026/01/22 19:20] (current) – [Answer:] dshoop | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| {{tag> faq}} | {{tag> faq}} | ||
| - | When lsetting | + | When setting |
| ===== Answer: ===== | ===== Answer: ===== | ||
| Line 10: | Line 10: | ||
| * metal feeler gauges thermally change dimension | * metal feeler gauges thermally change dimension | ||
| * dangerous to use on hot plate | * dangerous to use on hot plate | ||
| - | * damage bedplate | + | * damage bedplate |
| - | * sets to arbitrary height | + | * sets to arbitrary |
| The gcode z offset needs set to achieve an affect, a squish, on the filament which must be observed rather than set to some arbitrary height we measure. | The gcode z offset needs set to achieve an affect, a squish, on the filament which must be observed rather than set to some arbitrary height we measure. | ||
| Read more about [[understanding the gcode z offset]] | Read more about [[understanding the gcode z offset]] | ||
/app/data/attic/why_not_feeler_gauges.1758399564.txt.gz · Last modified: by dshoop