tune_extruder_rotational_distance
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| tune_extruder_rotational_distance [2025/09/13 23:31] – external edit 127.0.0.1 | tune_extruder_rotational_distance [2025/09/14 01:48] (current) – dshoop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Tuning Extruder Rotational Distance ====== | ====== Tuning Extruder Rotational Distance ====== | ||
| - | {{tag> setup tuning | + | {{tag> setup tuning}} |
| An accurate extruder rotational distance tuned for your specific extruder head is critical, if off so will all of [[Klipper]]s extrusion calculations. This should be done before other tuning and calibrations relating to extruding filament. | An accurate extruder rotational distance tuned for your specific extruder head is critical, if off so will all of [[Klipper]]s extrusion calculations. This should be done before other tuning and calibrations relating to extruding filament. | ||
/app/data/attic/tune_extruder_rotational_distance.1757820704.txt.gz · Last modified: by 127.0.0.1