Differences

This shows you the differences between two versions of the page.

--- tune_extruder_rotational_distance [2025/09/07 22:40] – sysmgr
+++ tune_extruder_rotational_distance [2025/09/14 01:48] (current) – dshoop
@@ Line 1: / Line 1: @@
-====== 06) Tuning Extruder Rotational Distance ======
+====== Tuning Extruder Rotational Distance ======
-{{tag> setup tuning setupBlog}}
+{{tag> setup tuning}}
 An accurate extruder rotational distance tuned for your specific extruder head is critical, if off so will all of [[Klipper]]s extrusion calculations. This should be done before other tuning and calibrations relating to extruding filament.
@@ Line 6: / Line 6: @@
 Ellis's Tuning Guide provides a good explanation and covers the canonical process for tuning the value. See https://ellis3dp.com/Print-Tuning-Guide/articles/extruder_calibration.html
-The best video resource for demonstrating this process is 00:00:56 into this [[https://www.youtube.com/watch?v=mCcP8dffwLk|YouTube video]].
+The best video resource for demonstrating this process is 00:02:22 into this [[https://youtu.be/mCcP8dffwLk?t=142|YouTube video]] by Wild Rose Builds.