Differences

This shows you the differences between two versions of the page.

--- screws_tilt_calculate [2025/09/14 00:31] – dshoop
+++ screws_tilt_calculate [2025/09/20 16:33] (current) – dshoop
@@ Line 11: / Line 11: @@
 IMPORTANT: You MUST always do a G28 before using this command.
-For instructions on running SCREWS_TILT_CALCULATE read these [[https://www.klipper3d.org/Manual_Level.html#adjusting-bed-leveling-screws-using-the-bed-probe|klipper docs] and you can watch [[ystc|this video]] for an overview of the process.
+==== [SCREWS TILT ADJUST] ====
+SCREWS_TILT_CALCULATE makes use of configuration stanza in [[printer.cfg]] to define the positions on the bed screw. These positions are measured from the probe position NOT the nozzle position. The [[z probe]] which is in the rear left corner of the print head should be over top the bed screw position when measured.
+Below is an example for the Neptune 4 (standard)
+<code>
+[screws_tilt_adjust]
+screw1_name: rear left screw
+screw1: 55,180
+screw2_name: rear right screw
+screw2: 225,180
+screw3_name: front right screw
+screw3: 225,10
+screw4_name: front left screw
+screw4: 55,10
+horizontal_move_z: 10
+speed: 200
+screw_thread: CW-M4 # Use CW for Clockwise and CCW for Counter Clockwise
+</code>
+See the [[Klipper]] docs for more.