Differences

This shows you the differences between two versions of the page.

--- run_bed_mesh [2025/10/07 05:43] – ↷ Links adapted because of a move operation dshoop
+++ run_bed_mesh [2025/11/05 18:34] (current) – [Adaptive Bed Meshes] dshoop
@@ Line 1: / Line 1: @@
 ====== How to run a Bed Mesh ======
-{{tag>faq}}
+{{tag>faq articles setup}}
 ==== Defining the Bed Mesh ====
@@ Line 51: / Line 51: @@
 ==== Adaptive Bed Meshes ====
+Read the Orca docs on [[https://github.com/SoftFever/OrcaSlicer/wiki/adaptive-bed-mesh|Direct Adaptive Bed Mesh Compensation]]
 Use the following in Orca's Printer Machine Start gcode:
 <code>
 BED_MESH_CLEAR
+G28
 BED_MESH_CALIBRATE mesh_min={adaptive_bed_mesh_min[0]},{adaptive_bed_mesh_min[1]} mesh_max={adaptive_bed_mesh_max[0]},{adaptive_bed_mesh_max[1]} ALGORITHM=[bed_mesh_algo] PROBE_COUNT={bed_mesh_probe_count[0]},{bed_mesh_probe_count[1]} ADAPTIVE=0 ADAPTIVE_MARGIN=0
 </code>
+While the defaults (-99999,-99999 & 99999,99999) will specify the whole plate is probe-able, this isn't actually the case. If you find the printer tries to probe beyond the plate borders you just need to copy in your bed mesh boundaries to Orca's Printer settings, yet the defaults will work unless you're printing close to the ends of the bed.
+== Example for N4 and N4Pro: ==
+printer.cfg file
+<code>
+[bed_mesh]
+mesh_min:10,21
+mesh_max:210,211
+</code>
+Orca Printer Configuration:\\
+{{:orca_adaptive_bed_mesh_settings.jpg?465|}}
-Read the Orca docs on [[https://github.com/SoftFever/OrcaSlicer/wiki/adaptive-bed-mesh|Direct Adaptive Bed Mesh Compensation]]