Differences

This shows you the differences between two versions of the page.

--- probe_calibration [2026/08/03 21:40] – dshoop
+++ probe_calibration [2026/08/03 21:41] (current) – dshoop
@@ Line 6: / Line 6: @@
 {{:shopping.png?150|}}
-== Please Note ==
+=== Please Note ===
 Calibrating the z probe is NOT the same as setting the gcode z offset.
@@ Line 15: / Line 15: @@
 Like many things Klipper, you'll need to use at least Fluidd to access the Klipper console. You can also use it to edit [[printer.cfg]] if you don't use ssh or other methods.
-==== About Probe Calibrate ====
+===== About Probe Calibrate =====
 See https://www.klipper3d.org/Probe_Calibrate.html for details on probe calibration (being sure to read the "second page" it links to in the doc "Paper Test"). As the geometry of the toolhead fixes the location of the X and Y probe offsets, and they have already been provided by Elegoo in [[printer.cfg]] we only are concerned with calibrating the probe Z offset in this procedure.
@@ Line 27: / Line 27: @@
-==== Example ====
+===== Example =====
 In the Klipper [[console]] first home the tool and then enter the Probe Calibrate routine.