Differences

This shows you the differences between two versions of the page.

--- print_start_macro [2025/11/04 01:59] – dshoop
+++ print_start_macro [2025/11/04 02:03] (current) – dshoop
@@ Line 6: / Line 6: @@
 ...work in progress...
-See [[Print Start Workflows]] for an example of a recommended PRINT_START macro for the N4 series.
+**See [[Print Start Workflows]] for an example of a recommended PRINT_START macro for the N4 series.**
 **NOTE:** //In initial versions of [[Klipper]] that shipped as part of Elegoo's firmware distributions the PRINT_START macro was called automatically as part of the start of a new print. A latter version of Klipper changed this behavior. This meant that owners who relied on that behavior often experienced issues like the bed mesh not loading or other expected operations part of the start of printing not occurring.//