Differences

This shows you the differences between two versions of the page.

--- pressure_adavance [2025/10/04 00:56] – dshoop
+++ pressure_adavance [2025/11/08 18:02] (current) – dshoop
@@ Line 2: / Line 2: @@
 {{tag> about}}
+{{:linear_advance_example.jpeg?600|}}
+An easy explanation of Pressure Advance (also known as Linear Advance in Prusa firmware) can be found in the opening to [[https://help.prusa3d.com/article/linear-advance_2252|this article]] introducing the feature by Prusa Research:
+>Linear Advance (LA) is a technology that predicts the pressure build-up in the extruder when printing at higher speeds. The firmware of the printer uses that prediction to decrease the amount of filament extruded just before stopping and decelerating, which prevents blobs or artifacts at the sharp corners.
+Klipper's docs demonstrate this practically further:
 > Pressure advance does two useful things - it reduces ooze during non-extrude moves and it reduces blobbing during cornering. This guide uses the second feature (reducing blobbing during cornering) as a mechanism for tuning.\\
@@ Line 9: / Line 16: @@
 For instructions about tuning pressure advance see Orca's calibration tool documented at https://github.com/SoftFever/OrcaSlicer/wiki/pressure-advance-calib
+==== Pressure Advance and Nozzle Size ====
+Larger nozzles increase the flow rate by a cubic exponential. A 0.6mm nozzle has about __twice__ the flow rate as a 0.4mm nozzle. As the nozzle size increases Klipper generally requires a //lower// pressure advance for the same material. The rule of thumb being around two-thirds the value, when switching from a 0.4mm to a 0.6mm nozzle for example, but it must be recalibrated for each filament. Larger nozzles increase the flow rate, which changes the dynamics of extrusion pressure and requires adjustments to other settings like line width, print speed, and temperature to maintain print quality.