part_knocks_shifts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| part_knocks_shifts [2025/11/08 18:14] – dshoop | part_knocks_shifts [2026/07/25 22:06] (current) – dshoop | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Normally this is caused by a combination of the following issues: | Normally this is caused by a combination of the following issues: | ||
| + | |||
| + | ==== Bed not level ===== | ||
| + | |||
| + | Run [[SCREWS_TILT_CALCULATE]] to level the bed or to check that it’s level. | ||
| ==== Bad gcode Z Offset ==== | ==== Bad gcode Z Offset ==== | ||
| Line 32: | Line 36: | ||
| * Avoid crossing perimeters | * Avoid crossing perimeters | ||
| * Retract between layers and enable z hop on retraction | * Retract between layers and enable z hop on retraction | ||
| + | * Improve first layers: [[tips_better_first_layers]] and [[first_layer_adhesion]] | ||
/app/data/attic/part_knocks_shifts.1762643641.txt.gz · Last modified: by dshoop