orca_calibrations
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| orca_calibrations [2026/01/13 19:28] – dshoop | orca_calibrations [2026/01/14 00:00] (current) – dshoop | ||
|---|---|---|---|
| Line 15: | Line 15: | ||
| For calibrating flow ratio, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker: https:// | For calibrating flow ratio, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker: https:// | ||
| - | Additionally you may want to perform some experiments to address overhang and bridging settings. | + | Additionally you may want to perform some experiments to address overhang and bridging settings. Both the slicer speeds differentiated over the overhang % can be calibrated or adjusted. |
| + | |||
| + | The Temperature Tower, as part of evaluating & calibrating extruder temperature, | ||
| + | |||
| + | Klipper has built in test towers to vary any parameter or variable over a range based on Z height and can be used to build all sorts of tests to calibrate quickly. | ||
| ==== Additional Resources ==== | ==== Additional Resources ==== | ||
/app/data/attic/orca_calibrations.1768350537.txt.gz · Last modified: by dshoop