Differences

This shows you the differences between two versions of the page.

--- orca_calibrations [2025/10/23 14:32] – ↷ Page name changed from orca_calibration to orca_calibrations dshoop
+++ orca_calibrations [2026/01/14 00:00] (current) – dshoop
@@ Line 9: / Line 9: @@
   * pressure advance
   * extrusion temperatures
+  * gcode z offset
 A great guide that would be hard to do better in terms of explanations is at  https://www.obico.io/blog/orcaslicer-comprehensive-calibration-guide/
-For calibrating flow rate, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker: https://www.printables.com/model/1113488-flexi-flow-calibration-tool-v4-by-ck3d
+For calibrating flow ratio, I prefer the following calibration test over the Orca test as it’s less subjectively focused and more functionality focused, uses way less filament and prints quicker: https://www.printables.com/model/1113488-flexi-flow-calibration-tool-v4-by-ck3d
-Additionally you may want to perform some experiments to address overhang and bridging settings.
+Additionally you may want to perform some experiments to address overhang and bridging settings. Both the slicer speeds differentiated over the overhang % can be calibrated or adjusted.
+The Temperature Tower, as part of evaluating & calibrating extruder temperature, has features for evaluate of the temperature on bridges (top) and overhangs (left and right sides).
+Klipper has built in test towers to vary any parameter or variable over a range based on Z height and can be used to build all sorts of tests to calibrate quickly.
 ==== Additional Resources ====