good_retraction_settings
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| good_retraction_settings [2025/09/14 02:15] – created dshoop | good_retraction_settings [2025/09/14 02:26] (current) – dshoop | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ==== Answer: === | ==== Answer: === | ||
| - | 0.8mm retraction at 55mm/s with 0.6mm of spiral z-hop. | + | 0.8mm retraction at 55mm/s with 0.6mm of spiral z-hop. Spiral z-hop requires Orca Slicer and that gcode arcs are enabled both on the printer in [[printer.cfg]] and in Orca. |
| Enable retratcion on layer change and moves over certain lengths. | Enable retratcion on layer change and moves over certain lengths. | ||
/app/data/attic/good_retraction_settings.1757830525.txt.gz · Last modified: by dshoop