first_time_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| first_time_setup [2025/11/05 18:38] – [Setting Up Your Neptune 4 Printer For The First Time] dshoop | first_time_setup [2025/11/05 18:46] (current) – dshoop | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| * A word about [[print_start_macro]] | * A word about [[print_start_macro]] | ||
| * A word about [[silicone_spacers|silicon spacers]] | * A word about [[silicone_spacers|silicon spacers]] | ||
| + | |||
| + | Now it would be a good time to enable Orca's Direct Adaptive Bed Mesh Compensation. See [[run_bed_mesh]] for steps. Use these adaptive bed meshes generated at print time and just the size of the object for a fresh mesh. | ||
| + | |||
| + | |||
| Line 40: | Line 44: | ||
| === Calibrate a profile for your filament === | === Calibrate a profile for your filament === | ||
| - | If you're not using a filament with and already defined filament profile it's recommended you calibrate a profile for it as it will result in improvements over using any default profiles (which are more of a suggested basis to start from.) | + | If you're not using a filament with and already defined filament profile it's recommended you calibrate a profile for it as it will result in improvements over using any default profiles (which are more of a suggested basis to start from.) |
| Orca slicer offers excellent calibration tools for determining common filament parameters. These can and will vary between the filament you're using, even with respect sometimes to filament color. | Orca slicer offers excellent calibration tools for determining common filament parameters. These can and will vary between the filament you're using, even with respect sometimes to filament color. | ||
| Line 54: | Line 58: | ||
| Learn to use [[Orca Slicer]] | Learn to use [[Orca Slicer]] | ||
| - | |||
| - | Perform [[Orca Calibrations]] to build a [[filament profile]] for the specific filament you will be using. These filament profiles will vary between material (PLA, PETG, TPU, ASA, ABS, ...), type (standard, high speed, high temp, plus, " | ||
| - | |||
| - | Configure Orca's Direct Adaptive Bed Mesh Compensation. See [[print_start_workflows|Print Start Workflows]] for steps. | ||
/app/data/attic/first_time_setup.1762385932.txt.gz · Last modified: by dshoop