first_time_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| first_time_setup [2025/09/17 22:41] – dshoop | first_time_setup [2025/09/20 16:24] (current) – dshoop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Setting Up Your Neptune 4 Printer For The First Time ====== | ====== Setting Up Your Neptune 4 Printer For The First Time ====== | ||
| - | {{tag>setup}} | + | {{tag>articles}} |
| Line 20: | Line 20: | ||
| * A word about [[PRINT_START macro]] | * A word about [[PRINT_START macro]] | ||
| - | * A word about [[silicon_spacers|silicon spacers]] | + | * A word about [[silicone_spacers|silicon spacers]] |
| Line 47: | Line 47: | ||
| Perform [[Orca Calibrations]] to build a [[filament profile]] for the specific filament you will be using. These filament profiles will vary between material (PLA, PETG, TPU, ASA, ABS, ...), type (standard, high speed, high temp, plus, " | Perform [[Orca Calibrations]] to build a [[filament profile]] for the specific filament you will be using. These filament profiles will vary between material (PLA, PETG, TPU, ASA, ABS, ...), type (standard, high speed, high temp, plus, " | ||
| + | ==== Notes ==== | ||
| + | Do not tighten or adjust the lock nuts for the lead screw couplers to the gantry. They are set at the factory (lock nuts) and need to be loose. Adjusting lock nuts damages them. | ||
| - | ==== Should you update the " | + | === Should you update the " |
| No. < [[should_update_firmware|Discussion]] > | No. < [[should_update_firmware|Discussion]] > | ||
/app/data/attic/first_time_setup.1758163301.txt.gz · Last modified: by dshoop