Differences

This shows you the differences between two versions of the page.

--- first_time_setup [2025/09/09 02:38] – sysmgr
+++ first_time_setup [2025/09/20 16:24] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== Setting Up Your Neptune 4 Printer For The First Time ======
-{{tag>setup}}
+{{tag>articles}}
@@ Line 14: / Line 14: @@
   - A word about the [[bed_mesh]]
   - [[run_a_full_bed_mesh|Run a full bed mesh]]
-  - [[inspect_bed_mesh]Inspect the bed mesh for gross warpage]
+  - [[inspect_bed_mesh|Inspect the bed mesh for gross warpage]]
-  - [[Adjust Nozzle Height - Z Offset]]
+  - [[how_should_i_set_the_z_offset_to_adjust_nozzle_height|Adjust Nozzle Height - Z Offset]]
     - paper method
     - baby step calibrated
   * A word about [[PRINT_START macro]]
-  * A word about [[silicon_spacers|silicon spacers]]
+  * A word about [[silicone_spacers|silicon spacers]]
@@ Line 40: / Line 40: @@
 Use your slicer to create a primitive object, a cube, and slice it with your test slicer settings and try to print it.
+=== Next Steps ===
-==== Should you update the "firmware" ====
+Learn to use [[Orca Slicer]]
-No. < discuss >
+Perform [[Orca Calibrations]] to build a [[filament profile]] for the specific filament you will be using. These filament profiles will vary between material (PLA, PETG, TPU, ASA, ABS, ...), type (standard, high speed, high temp, plus, "silk", matte, ...), brand and even color.
+==== Notes ====
+Do not tighten or adjust the lock nuts for the lead screw couplers to the gantry. They are set at the factory (lock nuts) and need to be loose. Adjusting lock nuts damages them.
+=== Should you update the "firmware" ===
+No. < [[should_update_firmware|Discussion]] >