Differences

This shows you the differences between two versions of the page.

--- first_layer_adhesion [2025/09/19 19:17] – dshoop
+++ first_layer_adhesion [2025/09/19 19:54] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== Why can't I get a good first layer? ======
-====== Why Won't my prints stick to the bed? ======
+====== Why won't my prints stick to the bed? ======
-{{tag> faq}
+{{tag> faq}}
 ===== Answer:=====
@@ Line 18: / Line 18: @@
 Level the bed with the [[SCREWS_TILT_CALCULATE]]
+==== First layer speeds too fast ====
+Try slowing down to 30mm/s.
+First layer speeds depend on filament material and other factors. Speeds for first layers tend to be under 60mm/s and as slow as 20mm/s for some filaments.
 ===== Discusion: =====