Differences

This shows you the differences between two versions of the page.

--- dimensional_accuracy_compensation [2025/09/08 12:16] – sysmgr
+++ dimensional_accuracy_compensation [2025/09/14 02:08] (current) – dshoop
@@ Line 1: / Line 1: @@
 ====== Orca Dimensional Accuracy Compensation ======
-{{tag> about setup faq}}
+{{tag> about}}
 Orca Docs: https://github.com/SoftFever/OrcaSlicer/wiki/tolerance-calib
 BambuLabs Wiki: https://wiki.bambulab.com/en/software/bambu-studio/xy-hole-contour-compensation
+https://www.obico.io/blog/tolerance-test-in-orcaslicer-a-comprehensive-guide/
 From: ''u/hotellonely'' on [[https://www.reddit.com/r/OrcaSlicer/comments/1b1hj1v/comment/m8xf60t/|Reddit]] is this great concise explanation:
-  In your model, you have 2x holes with 1mm diameter, and their distance between their centroid should be 10mm. You also have a corresponding part that can be clipped into the holes.
+[Imagine] in your model, you have 2x holes with 1mm diameter, and their distance between their centroid should be 10mm. You also have a corresponding part that can be clipped into the holes.
 Shrinkage: After you print, you found that the distance of centroids is 9.97mm. translating to a 99.7% shrinkage rate.