Differences

This shows you the differences between two versions of the page.

--- bed_mesh [2025/10/03 20:04] – dshoop
+++ bed_mesh [2025/12/01 20:57] (current) – dshoop
@@ Line 5: / Line 5: @@
 {{ :bed_mesh.png |}}
-The bed mesh is a probed map of the surface of the bed plate, normally automated and with a z probe, that describes how **//flat//** (not how **//level//**) the surface of the bed is above the level z-plane. It's a map of the hills and valleys decribing the warpage of build surface. The bed mesh variance, shown above is what we care about, as it should be less than 2x our layer height.
+The bed mesh is a probed map of the surface of the bed plate, normally automated and with a z probe, that describes how **//flat//** (not how **//level//**) the surface of the bed is above the level z-plane. It's a map of the hills and valleys decribing the warpage of build surface. The bed mesh variance, shown above is what we care about, as it should be less than 2x our layer height for best results. (Yet Klipper can normally compensate for a lot more.)
 It's often erroneously called "ABL", "Automatic Bed Leveling", yet has nothing to do with the bed being level.