bed_mesh
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bed_mesh [2025/09/17 22:29] – dshoop | bed_mesh [2025/09/17 23:04] (current) – dshoop | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== | + | ====== Bed Mesh ====== |
| {{tag> | {{tag> | ||
| Line 8: | Line 8: | ||
| It's often erroneously called " | It's often erroneously called " | ||
| + | |||
| + | ==== Generating a Bed Mesh ==== | ||
| + | |||
| + | See [[run_bed_mesh]] | ||
| ==== How to Interpret the Bed Mesh ==== | ==== How to Interpret the Bed Mesh ==== | ||
| Line 15: | Line 19: | ||
| === Variance === | === Variance === | ||
| - | The variance is the difference between the highest spot on the plate above the level plane to the lowest spot on the plate below the level plane. It's calculated for you in [[Fluidd]' | + | The variance is the difference between the highest spot on the plate above the level plane to the lowest spot on the plate below the level plane. It's calculated for you in [[Fluidd]]'s Tuning page. |
| So long as the variance above isn't much more than a layer height, and variance below isn't much more than layer height, the printer can easily compensate and likely won't cause functional or cosmetic issues. So a variance of less than 1.5 time layer height should be fine. | So long as the variance above isn't much more than a layer height, and variance below isn't much more than layer height, the printer can easily compensate and likely won't cause functional or cosmetic issues. So a variance of less than 1.5 time layer height should be fine. | ||
/app/data/attic/bed_mesh.1758162596.txt.gz · Last modified: by dshoop