Differences

This shows you the differences between two versions of the page.

--- after_nozzle_change [2025/11/08 02:33] – created dshoop
+++ after_nozzle_change [2025/12/03 22:56] (current) – removed dshoop
@@ Line 1: / Line 1: @@
-====== What do I need to do after I swap the nozzle or hotend? ======
-==== If you changed the whole tool head or the extruder or extruder gears... ====
-Be sure to [[tune_extruder_rotational_distance|tune extruder rotational distance]] before any other tuning or calibrations.
-====== Tools ======
-  * angled 6mm socket (or size of your nozzle
-  * pair of large needle nose pliers
-===== To swap the nozzle ======
-Heat to 20C degrees hotter than your usual extrusion temperatures.
-===== Things to do =====
-An //ordered// list
-  - PID Tune
-  - calibrate probe z offset
-  - adjust slicer layer heights and line widths if you changed the nozzle size.
-  - set gcode z offset
-  - calibrate flow ratio
-  - calibrate pressure advance
-  - calibrate extrusion temperature
-  - calibrate max volumetric flow rate