Differences

This shows you the differences between two versions of the page.

--- adaptive_bed_mesh [2025/09/17 23:04] – [Orca Support] dshoop
+++ adaptive_bed_mesh [2026/08/18 15:14] (current) – dshoop
@@ Line 1: / Line 1: @@
-====== Adpative Bed Mesh ======
+====== Adaptive Bed Mesh ======
 {{tag>about}}
@@ Line 17: / Line 17: @@
 ==== Orca Support ====
-Support for adaptive bed meshes is exposed directly by Orca satrting in V2.0, requiring no additional plug-ins or alterations to firmware as part of its [[https://github.com/SoftFever/OrcaSlicer/wiki/adaptive-bed-mesh|Direct Adaptive Bed Mesh Compensation]]
+Support for adaptive bed meshes is exposed directly by Orca satrting in V2.0, requiring no additional plug-ins or alterations to firmware as part of its [[https://github.com/OrcaSlicer/OrcaSlicer/wiki/printer_basic_information_adaptive_bed_mesh|Direct Adaptive Bed Mesh Compensation]]
 It's dirt simple to implement, see [[run_bed_mesh]]